Graisse antirouille no 2

(Material Safety Data Sheet)
PRODUCT AND COMPANY IDENTIFICATION
TRADE NAME: NEVASTANE GREASE XMF 00, 0, 1 AND 2

CHEMICAL NAME AND SYNONYMS: MIXTURE
MANUFACTURER/SUPPLIER'S NAME:
TOTAL LUBRICANTS CANADA INC. Tel.: (514) 595-7579 or 1-800-463-3955 24 HOURS EMERGENCY: Call CHEMTREC 1-800-424-9300 or 703-527-3887 PRODUCT USE: Grease for incidental food contact (CFIA N) WHMIS CLASS AND DESCRIPTION - This product is not regulated by the WHMIS. Meets the FDA specification of section 21CFR178.3570 Other Hazards Classification: Hazardous Material Information System (USA) National Fire Protection Association (USA) PROTECTION HAZARD: MINIMAL= 0 SEVERE = 4 COMPOSITION/INFORMATION ON INGREDIENTS White mineral oil Aluminum stearoyl benzoyl hydroxide ADDITIONAL REGULATORY INFORMATION - No hazardous ingredients as defined by the Canadian Hazardous Products Act (BILL C70) or by OSHA 29 CFR GREASE NEVASTANE XMF SERIE TLC MSDS 3/22/2013

- Canadian DSL status: All ingredients are listed. * No components of this product have been found carcinogenic or potential carcinogen. Does not contain ingredients that are listed as carcinogenic or potential carcinogen by OSHA, IARC or the U.S. National Toxicology Program (NTP). This product or its components have no teratogenic or mutagenic effects known.
DROPPING POINT:
FLASH POINT:
AUTOIGNITION TEMPERATURE:
DENSITY (g/cm at 20°C):
VAPOR DENSITY (AIR = 1):
SOLUBILITY IN WATER:
SOLUBILITY IN SOLVENT:
APPEARANCE:
PHYSICAL STATE AT 20°C:
STABILITY AND REACTIVITY
STABILITY:
Stable under recommended storage conditions. CONDITIONS TO AVOID:
Avoid excessive heat, open flames, static electricity, sparks,ignition point and formation of oil mist. PRODUCTS TO AVOID:
Oxidizing agents, strong acids and bases. HAZARDOUS DECOMPOSITION PRODUCTS:
potentially toxic gases such as carbon monoxide, carbon dioxide, various hydrocarbons, aldehydes and soot. FIRE FIGHTING MEASURES
FLASH POINT (COC):
>216°C (420°F)
AUTOIGNITION TEMPERATURE (°C):
Drop point:>180°C
EXTINGUISHING MEDIA:
Foam, Dry chemical and CO2
HAZARDOUS COMBUSTION PRODUCTS:
Incomplete combustion and thermolysis produces potentially toxic gases such as carbon monoxide, carbon dioxide, various hydrocarbons, aldehydes and soot.
SPECIAL FIRE FIGHTING PROCEDURES:
Do not enter confined fire space without adequate protective clothing and an approved positive self-contained breathing apparatus. Use water to cool fire exposed containers. TOXICOLOGICAL INFORMATION
INHALATION:
Not classified. Inhalation of high concentration of vapour or aerosols may cause an irritation of the upper respiratory tract. CONTACT WITH EYES:
GREASE NEVASTANE XMF SERIE TLC MSDS 3/22/2013

SKIN CONTACT:
Not classified. High pressure injection of the product under the skin may have very serious consequences even though no symptom or injury be apparent. INGESTION:
In case of ingestion small quantities, no important effect observed. In case of ingestion larger amount: abdominal pain, diarrhea,. Do not induce vomiting. ACCIDENTAL RELEASE MEASURES
SPILL AND LEAK PROCEDURES:
Eliminate all ignition sources. Stop leak only if safe to do so. Absorb residue or small spills with absorbent material and remove to non-leaking containers for disposal. HANDLING AND STORAGE
STORAGE AND HANDLING:
Store in cool, dry, ventilated area, away from heat and ignition sources. Use good personal hygiene. Always keep the container closed. EXPOSURE CONTROLS / PERSONAL PROTECTION
VENTILATION:
Mechanical ventilation is recommended.
RESPIRATORY PROTECTION:
If mist present, chemical cartridge respirator is recommended. Exposure limit: oil mist = 10 mg/m3 , for 15 minutes. Exposure limit: oil mist = 5 mg/m3 , for 8 hours. Resistant gloves (Viton, Nitrile, Neoprene) are recommended when handling this material.
EYE PROTECTION:
Chemical safety goggles are recommended.
OTHER PROTECTION:
In confined spaces or where the risk of skin exposure is higher, resistant clothing or apron should be worn. DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHODS:
Consult relevant local authorities. Reclaim or dispose of at a licensed waste disposal company. Incinerate with approval of appropriate local authority.
INHALATION:
Remove person to fresh air. See a physician if irritation persists.
CONTACT WITH EYES:
Flush immediately with water for at least 15 minutes.
CONTACT WITH SKIN:
Wash contaminated skin with mild soap and water. See a physician if irritation persists.
INGESTION:
This product has a low toxicity. May cause nausea and have a laxative effect. Do not induce vomiting. Contact an Anti-Poison Center (1-800-463-5060). GREASE NEVASTANE XMF SERIE TLC MSDS 3/22/2013

EMERGENCY 24 HOURS: Call CHEMTREC at 1-800-424-9300 or 703-527-3887 HAZARDS IDENTIFICATION
HEALTH EFFECTS:
This product do not present a danger of intoxication.
ENVIRONMENTAL IMPACT:
Do not discharge this product into the environment.
PHYSICO-CHEMICAL
HAZARDS: No specific risk of fire or explosion under normal condition of use.
ECOLOGICAL INFORMATION
ENVIRONMENTAL EFFECTS:
Do not allow product or runoff from fire control to enter storm or sanitary sewers, lakes, rivers, streams, or public waterways. Block off drains and ditches. Provincial regulations require and federal regulations may require that environmental and/or other agencies be notified of a spill incident. Spill area must be cleaned and restored to original condition or to the satisfaction of authorities.
BIODEGRADABILITY: NOT READILY BIODEGRADABLE.

TRANSPORTATION INFORMATION TRANSPORTATION (TDG) SHIPPING NAME: CLASS DESCRIPTION: REGULATORY INFORMATION This product has been classified in accordance with the hazard criteria of the Controlled Products. Regulations (CPR) and the MSDS contains all the information required by the CPR. THIS PRODUCT IS NOT A WHMIS CONTROLLED SUBSTANCE. DSL/NDSL Status: This product, or all components, are listed on the Domestic Substances List, as required under the Canadian Environmental Protection Act. This product and/or all components are listed on the U.S. EPA TSCA Inventory. Other Regulatory Status: No Canadian federal standard; however, for general discharge guidance, federal installations limited to 15 mg/L for total oil and grease. Provincial criteria are likely and should be requested when notifying provincial authorities. GREASE NEVASTANE XMF SERIE TLC MSDS 3/22/2013

ADDITIONAL INFORMATION Prepared by: André St-Jean, Chemist Revised on March 20, 2013 We believe that technical information and recommendations contained herein to be reliable and accurate. However, we provide these data without warranty or guarantee of any kind, expressed or implied. We assume no responsibility for any loss, damage, or expense, direct or consequential, arising from the use of products described herein. GREASE NEVASTANE XMF SERIE TLC MSDS 3/22/2013

Source: http://www4.total.fr/pdf/Canada/produitslub/EN/fiches_securite/Industriels/GREASE%20NEVASTANE%20XMF%20SERIE%20TLC%20MSDS.pdf